Nissan GT-R R35 Electrical Wiring Diagram

The Nissan GT-R R35 Wiring Diagrams and Electrical Manual provides detailed schematics and instructions for the vehicle's electrical system. This guide is essential for troubleshooting, repairs, and modifications, offering clear diagrams, connector views, and step-by-step procedures to assist technicians and enthusiasts in maintaining the GT-R's complex electrical network

• Home Page>>
• Nissan GT-R R35 Factory Workshop Manual>>
• Nissan GT-R R35 Engine Workshop Manual>>
• Nissan GT-R R35 Body Repair Manual>>

Electrical and wiring problems in the Nissan GT-R R35 can be caused by both general factors and specific features of the complex electronics and high-performance systems of this car. Here are some common problems and recommendations for what to pay attention to:

1. Battery and charging system problems

Problem: The GT-R R35 battery can drain quickly, especially if the car is not used often. This is due to the high load on the battery due to many electronic systems, even in standby mode.

Solution: Regularly check the battery condition and charge level. Use a battery charger if the car is not used for a long time. Make sure the alternator and charging system are working properly.

2. Control unit (ECU, TCM) malfunctions

Problem: Electronic control units such as the ECU (Engine Control Unit) and TCM (Transmission Control Module) can malfunction, causing errors in the engine or transmission.

Solution: Perform regular diagnostics using specialized equipment to check the condition of the control units. Update the software of these modules in accordance with the manufacturer's recommendations.

3. Overheating and sensor failures

Problem: Oil pressure, temperature, detonation and other sensors can overheat and fail, especially during active use of the car.

Solution: Regularly check the condition and accuracy of the sensors. If errors or malfunctions occur, immediately replace the problematic sensors. Install additional cooling systems if the car is used on the track.

4. Wiring and connection problems

Problem: High vibrations and loads can lead to loose connections, damaged wiring or short circuits.

Solution: Regularly check the condition of the wiring, especially in places subject to high vibration or overheating. Pay attention to the connectors and terminals, clean them from oxidation if necessary and tighten loose connections.

5. Errors in the operation of the all-wheel drive system (ATTESA E-TS)

Problem: The electronic all-wheel drive system ATTESA E-TS may encounter errors due to faults in sensors or wiring, which affects the distribution of power between the axles.

Solution: Monitor the condition of the all-wheel drive system and diagnose it if errors occur. Check the condition of the wiring, connectors and sensors associated with the ATTESA system.

6. Problems with electronics in the cabin

Problem: Electronic elements in the cabin, such as the multimedia system, climate control system, may encounter problems related to wiring or failures in the control units.

Solution: Periodically check the operation of all systems in the cabin. If failures or malfunctions are detected, diagnose the wiring and control units. If necessary, update the firmware of multimedia and other systems.

7. Lighting Problems

Problem: LED headlights and taillights may fail due to problems with the wiring or light control units.

Solution: Check the condition of the lights and wiring regularly, especially if you notice flickering or the lights going out. Make sure the light control units are working correctly.

Regular checks: Perform regular checks of all major electrical systems and connections. Pay special attention to wiring in areas of high temperature and vibration.

Use of original components: When replacing wires, connectors and control units, use only original or manufacturer-recommended components.

Diagnostics: Use specialized diagnostic equipment to check the condition of electronics and control units.

Install additional protection systems: In extreme operating conditions, consider installing additional coolers for electrical systems and protecting wiring from mechanical damage.